Mbm-corporation iCREASE AIR Manuel d'utilisateur télécharger pdf (Page 18)

Saving Custom Crease Jobs: Press the Crease Mode Button > Custom > Enter In

Distance For each Crease in mm > Save > Select Position to save in 1, 2, 3, or 4.

Recalling Custom Crease Jobs: Press the Crease Mode Button > Custom > Recall >

Accept > Run > Feed.

Micro Adjusting the Crease Position: Press the adjust button from the run screen.

You can micro adjust each crease by pressing the arrow keys each direction. Each press

will adjust by 1/9th of a mm. Each adjustment is relative to the one before it so if you

adjust crease 1 by 3 clicks it will also move all the creases after it in the same direction.

To keep the subsequent creases in their same locations you would then need to adjust

them each back the number of clicks you adjusted the previous location, in this case 3

clicks.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Pas de commentaire

Mbm-corporation iCREASE AIR Manuel d'utilisateur Page 18