Mbm-corporation iCREASE EXCEL Manuel d'utilisateur télécharger pdf (Page 9)

Feeder Mode

Feed mode is the mode to run your icreaseEXCEL as a feeder into our CountCoat UV Coater. It

runs much slower than the other modes giving the sheets enough spacing to move through the

UV coater.

Home: Takes you back to the home screen.

Counter Reset: Resets the displayed counter to 0.

Jog Left and Right: Slowly advances the rollers left or right.

Batch Counter: Allows for stopping the machine after a batch number is reached.

Run: Turns on the transport and starts the feeding of paper.

Crease mode

Crease mode is used to apply a Compression Crease/Score to a piece of paper. In this mode

there are several Automatic Setup selections or you can do a custom selection and enter the

distance in mm.

Crease selections include half, tri-fold, z fold, letter fold, roll fold, gate fold, double gate, double

parallel, 3 perfect bind selections and 12 custom crease locations.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Pas de commentaire

Mbm-corporation iCREASE EXCEL Manuel d'utilisateur Page 9